When you turn on a faucet in Franktown and nothing comes out, it isn't a city problem you can call the utility about. Out here on the Front Range, your home runs on its own private well, and when the pump quits, the whole house goes dry: no showers, no flushing, no coffee. Paramount Plumbing gets these calls every week from homes off Highway 83, out toward Russellville, and down through Sedalia, and we know how to get water flowing again fast without guesswork.
What makes us different is simple: Paramount is run by Patrick, a licensed master plumber who works on the well, the septic system, and the home's plumbing all under one roof. Most plumbers won't touch a well, and most well drillers won't touch your home's pipes, which leaves rural homeowners bouncing between contractors who each blame the other. We handle the whole water system end to end, we're licensed and insured, and we answer the phone 24/7 at 719-888-3255 because a dead well pump on a January night can't wait until Monday.
Signs Your Well Pump Is Failing
A well pump rarely dies without warning. The most common early symptom we see in Franktown homes is a drop in water pressure, especially when more than one fixture is running, or faucets that sputter and spit air before the water comes. That air is often a clue that the pump is losing prime or that the water level in the well has dropped below where the pump can reach it, which happens more than people expect during dry Colorado stretches.
Other red flags include a pump that runs constantly and never shuts off, a pump that cycles on and off rapidly (short-cycling, usually a failing pressure tank or waterlogged bladder), dirty or sandy water, or a noticeable jump in your electric bill from a pump straining to keep up. Sometimes the pump itself is fine and the real culprit is the pressure switch, the pressure tank, a bad check valve, or corroded wiring down the well casing. Because we're licensed on both the well and the home side, we diagnose the actual failure point instead of just swapping parts and hoping.
If your water has gone completely out, the first thing worth checking is your breaker: well pumps trip breakers, and a reset occasionally buys you a day. But if it trips again or nothing changes, don't keep cycling it. Call us at 719-888-3255 and we'll walk you through what's safe to check before we roll a truck.
What a Well Pump Repair Actually Involves
Diagnosis comes first. We check your pressure tank, pressure switch, and the electrical side before assuming the pump itself is the problem, because pulling a submersible pump out of a 200- to 600-foot well is the most expensive part of the job and we don't want you paying for it if a $200 pressure switch fixes the issue. When the pump does need to come out, we pull the drop pipe and wiring, inspect the pump and the well seal, and check the wire and pipe for corrosion while everything is up top, since it's far cheaper to replace worn components now than to pull the well again in six months.
Most rural Franktown and Sedalia homes run a submersible pump set deep in the well, though some older or shallower properties use a jet pump in the well house or basement. Both wear out, and both are fixable. When we replace a pump we size it to your well's depth, your household demand, and your recovery rate rather than just matching whatever was there, which matters on properties where the static water level has changed over the years.
On new construction, we handle the well pump and pressure system as part of getting the home water-ready, and because we also do the septic and the interior plumbing, everything is designed to work together from day one. Whether it's a repair or a fresh build, you get one licensed plumber accountable for the whole water system. Call 719-888-3255 to get on the schedule.
What Well Pump Repair Costs on the Front Range
Honest answer: it depends on what failed and how deep your well is, and any plumber who quotes an exact number over the phone without seeing it is guessing. That said, we believe in upfront pricing, so here are realistic Front Range ranges. A pressure switch or minor electrical repair typically runs a few hundred dollars. A new pressure tank generally lands in the $800 to $2,000 range installed. A full submersible pump replacement, including pulling the pump, new wire and pipe as needed, and a proper pump sized to your well, commonly runs from around $2,500 to $6,000-plus, driven mostly by well depth and horsepower.
We're not the cheapest outfit in Douglas County, and we don't pretend to be. What you get for a premium rate is a licensed master plumber doing the work right the first time, quality components that survive Colorado winters, and no surprise upcharges once the truck is in your driveway. Every price is approved by you before we start the work, so you're never staring at a bill you didn't agree to.
Because well work and your home's plumbing overlap, we'll also flag anything that's about to cause a bigger problem, like a failing check valve or a pressure tank on borrowed time, so you can decide with full information. Want a straight, no-pressure estimate for your specific setup? Call 719-888-3255.
Why Local, Cold-Weather Experience Matters Out Here
Franktown and Sedalia winters are hard on well systems in ways a metro-Denver plumber may not think about. Well houses and pressure tanks sitting in unheated pump sheds are vulnerable to freezing, and a frozen or burst supply line will leave you without water and with water damage at the same time. We know which components fail in the cold, how to protect a well house, and how to get a frozen or burst line back in service fast, which is exactly the kind of call our 24/7 line is built for.
This is also OWTS country. Most homes out here pair a private well with a septic system governed by Colorado Regulation 43 and Douglas County OWTS permitting, and the two systems share the ground your water lives in. When we work on a well, we understand its relationship to the leach field, the setbacks, and the county rules, because we install and service septic systems too. That whole-property fluency is rare, and it means you're not explaining rural water to someone who mostly works on city hookups.
We live and work in this corner of Douglas County, so when you call, you get a local, licensed, insured plumber who can actually find your driveway. No water is an emergency, and we treat it like one, day or night, at 719-888-3255.
Frequently asked
How fast can you get to my Franktown home if my well pump quits?
We run a genuine 24/7 emergency line because losing water isn't a next-business-day problem. Call 719-888-3255 and we'll get to you as quickly as we can, day, night, or weekend. Because we're local to the Franktown and Sedalia area, we're not driving in from across the metro, and we can often talk you through a safe breaker or pressure-switch check while we're on the way.
How do I know if it's the pump, the pressure tank, or something else?
You often can't tell from inside the house, and that's fine. Rapid on-off cycling usually points to the pressure tank or switch, constant low pressure can mean a worn pump or a dropping water level, and sputtering air suggests the pump is losing prime. We diagnose the actual failure point before recommending a repair, so you don't pay to pull the pump if a cheaper part is the real culprit.
Why call a plumber instead of a well drilling company?
Most drillers focus on putting in the well and won't service your home's plumbing, and most plumbers won't touch a well at all, which leaves rural homeowners caught in the middle. Paramount is run by a licensed master plumber who handles the well, the septic, and the interior plumbing together, so one accountable pro covers your whole water system instead of pointing you to someone else.
What will it cost, and will I know the price before you start?
Yes. We give you an upfront price and get your approval before any work begins, so there are no surprises. Simple electrical or pressure-switch fixes run a few hundred dollars, a new pressure tank is typically $800 to $2,000 installed, and a full submersible pump replacement commonly runs $2,500 to $6,000-plus depending on your well's depth. We confirm the exact number on-site after we diagnose the real problem.